Pages

Monday, February 19, 2018

Bringing It All Together

After months of planning, experimenting, and exploration, we are finally ready to put all of our hard together into a final project. Last week we began work with our 6th-grade students to bring their laser cut project boards to life with the help of Bare Conductive Touch Boards.

We started the process by introducing our students to the touch boards, giving them time to look through the kits while we explained our vision for the final product. Next, we planned out where we would connect the boards using conductive paint. Each student traced their touch board on a central space within their design and penciled lines from each connection to the area they would like to highlight. This was helpful because they were able to notice areas where the lines overlapped and fix their work in pencil before the conductive paint was laid.

We decided to start small with 5 different touch points for each board. The boards allow for 12 but that is a large amount and we didn't want to overwhelm our students. With 5 connections we had the ability to skip sensors on the board so every other will be connected. We figured this might give us a little bit of wiggle room and make using the conductive paint less of a challenge. 

Included in each starter kit, along with the touch boards, was a set of stencils. We used the stencils paint connecting points to each sensor. Since we decided to try to connect the Touch Boards on the back, we set them aside to dry before tackling the paint on the front.


While the paint dried we got to work on creating sound clips. Our students have Chromebooks and have had experience using Voice Recorder Online. It isn't fancy but for our needs, it worked perfectly.


The hour we had with our students flew by! By the end of our work session, we were finally able to see their final projects taking shape. We are looking forward to getting the Touch Boards programmed and everything in place over the next month. Stay Tuned!

1 comment: